My friend ask me to do a replica of his myvi, honestly this is the most complicated.. i had to convert to this... MONSTER MOD MYVI!
from Tomica Toyota Passo
so far... i can say.. its coming along.. got through a few speed bumps
But.. it is coming along slowly.. hopefully this mold dries faster..
My first diecast mod with a custom bodykit...
and due to my college that just started, it would take some time for me to update as i have been given a whole lot of work. till the next post... thanks for reading..
p.s the range rover custom is on hold.. =D
from Tomica Toyota Passo
so far... i can say.. its coming along.. got through a few speed bumps
But.. it is coming along slowly.. hopefully this mold dries faster..
My first diecast mod with a custom bodykit...
and due to my college that just started, it would take some time for me to update as i have been given a whole lot of work. till the next post... thanks for reading..
p.s the range rover custom is on hold.. =D
7 comments:
good luck! ambitious mould work right there, but i see some progress ;-)
haha! hey bro, thanks alot.. yea i am working on the mould.. hopefully it hardens and turns out the way i want it.. hope to see you soon!
now that some very meticulous work you got there Ben!! It looks like your'e getting a handfull there. Just be patient with the drying process of the mold. Don't rush.
Good luck and I know it will turn out awesome! :-)
nice project mate!~... any idea how to convert the front lamp??? my project to convert the passo to myvi was stuck since i havent configured how to convert the front part... and to answer ur question on my blog i use putty which were used for filling crack on walls.. avaliable at almost every hardware shop... anyway there's another brand called BONDITE EPOXY PUTTY which were commenly used by modeller in malaysia to replace tamiya putty which were very costly.... hope that helps u a bit!~
hey bro! i have an idea on how to convert the passo headlamp to myvi.. as i can see the myvi passo head lamp just needs to be reshaped.. i dont know if i would work or not.. but you could use a low grit sand paper to slowly shape the passo lamp to a myvi.. then use sum putty to cover the remainding holes at the hadlamp of the diecast? or you could just use putty and cover up the passo headlamp holes and shape it into a myvi headlamp? hope it helps? because i dont normallt shape the lamps.. i just use the original cause it looks almost the same as the myvis.. takecare bro and thanks for the tips.
The information here is great. I will invite my friends here.
Thanks
Looks great. Good luck for finishing it off.
Post a Comment